Changing the low beam bulb on Renault Logan with his hands
25/09/2017
Renault Logan has always been considered a cheap and reliable service vehicle. Most of the repair works on the machine, you can run on their own, not spending their time and money to visit a specialized auto repair. And replacement bulb low beam in the headlamp, was not the exception. So, using our tips, you can easily make it a small maintenance your favorite car! First and foremost, what you need to know is what bulb type that is installed in cars Renault Logan is of type H4. And they are intended for both the near and distant light, as they have two filaments. This type of lamp is convenient because for a full audit of head light in the car is enough to change only 2 lamps. But the most significant drawback lies in the price: this lamp is more expensive than "separate" H1 and H7. On our site you can choose the right lamp H4 http://bocxod.ru/catalog/lampi12/golovnoy-svet/?filter[type2]=23 Now, we all know what kind of lamp you need, followed by the process of its replacement. To change the light bulb, we will for example left headlight, since the replacement involves removing the battery. On the right headlight bulb is changed similarly. First we will need to remove the battery, it will require two keys for 10 and 8 to remove the terminals with “+” and weight, as well as end head 13 to dismantle the mount of the battery (if equipped). Special attention should be paid to the fact that the first wires are removed from the masses “-”, and then only with “+”. After the battery was removed from its place we see respectively the block spotlight, center which includes a plastic cover, with a lock at the top. To remove this cover and get directly to the bulb it is necessary to press the thumb of one hand on a kind of foot (the latch), and at the same time from the bottom to pull the cover off. As the plastic is quite pliable, any difficulties in this process should arise. When we removed the plastic cover, we see a rubber gasket and the block with the wires connected to the light bulb. First, carefully remove the pad, hold while it is only necessary for the case, and then sealing the case. Remained the final touch. Before us is the spring pin that fixes the halogen lamp, securely holding her in its tenacious paws. However, do not be afraid! Remove the clip can be as easy as to put in place, it is only necessary to withdraw it from "hook" with a hook of the reflector by pressing a finger on its top. Next, take out the bulb itself from the headlight, hold it for metal legs and change to a new lamp, installing in reverse, similar to the withdrawal sequence. Replacement size or turn signal If you have a need to replace the front turn signal or replace the bulbs for the Parking lights, that is to say that their replacement is much more easier. The bulb that requires replacement, simply turn counter-clockwise and remove the burnt light source.